Friday, September 5, 2014

Project Update: Balance Rail Pin Holes and a Drill Press

After a couple of communications with Ernie Miller, author of the eBook most excellent, I've come to the conclusion I need to redrill all of the balance rail pin holes for each of the keys. This is based on comments from Mr. Miller - he stated that each key should tip freely forward on its own. Only a few of them do this. He says that in the event they don't, it probably means the balance rail pin holes are too small.

My solution is to carefully redrill all of these holes using my trusty drill press. This will ensure a perfect 90-degree angle for each cut. I'm hoping to get these done tonight, this weekend at the very latest.

Until then...

No comments:

Post a Comment